Dr. Brux - Night Guard Instructions

Instructions For Fit & Use

Dr. Brux was created by an Italian dental company with a long experience of producing single intraoral devices, used by dentists for mouth care, prevention and protection. Carefully follow the instructions below to obtain a correct custom fit. Adjustment should be made on the upper teeth:

1. Hold the "VDC System" adjustment device (plastic arch or Dipstick, as we call it) with the curved end pointing downwards and insert it in the night guard, starting from one of the two lateral holes. Once the first pin has been inserted expand the arch in such a way to line up the arch pins into the three front tray holes. And now finish off by inserting the second lateral pin into the night guard.

2. Before starting to custom fit the night guard, put it in your mouth to gain comfort and familiarity.

3. Holding the Disptick with the night guard as illustrated, completely immerse the night guard into boiling water for 6 seconds. Do not exceed 6 seconds as the night guard could lose its shape.

4. Take the night guard out of the water and shake off any excess water. It should be warm to the touch, but not hot enough to burn.

5. Insert the night guard in your mouth and bite gently. Now, with your lips closed, suck in air for approximately one minute to create a vaccum so the night guard can fit perfectly to your teeth.

6. Take the guard out of your mouth and hold it under cold water for 2 minutes. Now, take out the Dipstick and your night guard is ready for nightly use.

Recommendations

1. Do not throw the Dipstick away as you may want to re-mold the night guard every so often.

2. If the night guard is not comfortable or does not fit well, repeat the steps above with great care to Step 5.

3. If the night guard proves to be too long, or if you see any defects or bends in the night guard after customization you can shorten it by trimming any excess with a small pair of scissors.

4. Before storing your night guard away in its case, clean it by brushing with a normal toothbrush and cold water.

5. Never wash the night guard with hot water and avoid placing it near heat, as it may become unstable and lose its shape.

Disclaimer

Dr. Brux may be reshaped several times without its characteristics changing, so if it does not fit well, have no fear, you can always reshape Dr. Brux.

The Dr. Brux Night Guard is designed for permanent, not deciduous (milk) teeth. In cases of dental, gingival or TMJ disorders, orthodontic devices or removable dentures, ask your dentist before using Dr. Brux.



Sold Out	Sold Out	Sold Out	Sold Out

DR. BRUX NIGHT GUARD

Easy, fast and comfortable, Dr. Brux®, the first custom Bruxism (grinding) Night Guard, used to protect your teeth from Bruxism.

Simply dip Dr. Brux® into hot water (6 seconds), then insert it into your mouth to get a perfect fit.

ONE SIZE FITS ALL

Remoldable and comfortable to fit any size mouth. The Dr. Brux Night Guard may be reshaped several times without its characteristics changing, so if it does not fit well at first, have no fear; you can always reshape it.

The Dr. Brux Night Guard is made of a special biocompatible thermoplastic, with two pre-established hardnesses that provide stability, comfort and resistance over time.

CUSTOM TWO MATERIAL CONSTRUCTION

Dr. Brux® is made from a special thermoplastic material with two different hardnesses. The first is softer than the second, and stays in contact with the surface of your teeth and gums. The second, creates the support needed for the grinding and non occlusion position of the upper and lower arches.

Select Color :

Qty :

PARTNERS :

Accept Credit Cards Online